Navlaku trebam oprati i ne mogu je skinuti jer ne mogu otkačiti pojaseve. Jel netko skidao navlaku? Gdje da otkvačim pojaseve? :? :? Pokušala sam s donje strane, ali nema šanse, a ne da mi se jako potezati jer se bojim da ih ne oštetim...HEELP!!
Printable View
Navlaku trebam oprati i ne mogu je skinuti jer ne mogu otkačiti pojaseve. Jel netko skidao navlaku? Gdje da otkvačim pojaseve? :? :? Pokušala sam s donje strane, ali nema šanse, a ne da mi se jako potezati jer se bojim da ih ne oštetim...HEELP!!
Joj, ja imam lose iskustvo sa pranjem, oprala sam u mašini na 30C i na programu za vunu i svilu, i dosta se poderala. Bolje probaj ocistiti sa vlaznim maramicama.
auuu, ma daj?? Ne mogu je samo maramicama..baš je moram oprati..
iz uputa:
5.2 Seat cover
Removing the cover
• Loosen the shoulder belts by pressing the release button and pulling the shoulder belts towards you as far
as possible (28).
• Place the PrioriFix in the sleeping position and open the belt guard door (46).
• Pull the shoulder belts until the belt yoke on the back appears. Remove the shoulder belts from the belt
yoke (47).
• Tilt the clasp on the belt pad and pull it together with the shoulder belt through the belt slots. This is
easiest to do using the top belt slot (48).
• Remove both belt hooks by pushing the tab on the back of the seat downwards (49).
• Loosen the cover on all sides (50).
• Open the belt buckle.
• Pull the belts, belt pads, buckle sections and belt buckle through the openings in the cover (51).
• Remove the cover.
• Slide the belt pads off the shoulder belts (52).
Cleaning the cover
• Wash the cover and belt pads by hand (maximum of 30°C). Do not place them in the dryer. Also see the
care instructions on the cover itself.
Tip: It is advisable to buy an extra cover when purchasing the PrioriFix so that you can continue to use the
PrioriFix at all times, even when washing or drying the cover.
Reattaching the cover
• IMPORTANT! Slide the buckle sections together (53,1) and “click” them into the belt buckle (53,2).
• Slide the clean belt pads, textured side down, back onto the shoulder belts.
• Thread the shoulder belts through the large opening of the clasp (54).
• Open the buckle and thread the buckle, shoulder belts and buckle sections through the openings in the
cover (55).
• Place the cover over the edges of the release button and around the adjusting handle and secure it onto
the cover hooks (56).
• “Click” both belt hooks into position (57) and check to make sure they are securely fastened.
• Secure the shoulder belt clasps at the desired height in the belt slots (58).
• Attach the shoulder belts to the belt yoke (59).
• IMPORTANT! The red stitching on the shoulder belts must be facing the shell.
• Close the belt guard door (60).
• Fasten the belt buckle and close the flap on the cover (61).
• Check the functioning of the harness system and make sure the belts are not twisted.
link:
http://www.maxi-cosi.com/media/produ.../PrioriFix.pdf
duboki naklon! :mrgreen:
Puno hvala!
Uspješno sam skinula navlaku i oprala je u veš mašini na 30 stupnjeva. Sad je čista i mirišljava-izgleda ko nova! :D :D